Red copper Challenger II
Sexy red copper host - the same copper we use to make the copper heatsink for our handheld lasers.
This product is not suitable for new laser users, read below.
Buyer Attention: This model come without reverse polarity protection, the battery must inserted to the right direction(positive towards the diode).This product does not accept any form of returns unless the issue is related to the laser diode. Red copper is a softer copper without mixing any other metals and it can be damaged easily by any fall damages. The surface requires constant care and maintenance to prevent oxidation. Buyers must acknowledge these terms before purchasing this model.
Product Specs :
||Red copper 24*140mm with 20mm copper heatsink, 260g
||Two Flat top 18350 li-ion rechargeable batteries
Must follow: positive to the diode, negative to the tail.
Single mode / Multi-operation mode
On / off
Multi-operation mode with safety lock
Low power, half power, strobe, full power, SOS and electronics safety lock
Half-press the tail switch to cycle between each mode, the laser driver memorizes and starts with the operation mode that being used for more than three seconds during the last operation
Electronic safety lock
To prevent unauthorized use, half-press the tail switch three times within the first three seconds after the laser is on, the laser will switch to strobe mode before entering the safety lock.
Turn on the laser, wait one second and do five half-taps within three seconds, wait another 2 seconds, if the beam switch to strobe mode, then your laser is now unlocked.